Camera mount for 1-1/2 inch square board camera, to connect to servo for tilt or pan mechanism. I noticed on the last run I did of this mount that the servo horn hole was a little out of round. If your servo horn does not fit, a small amount of shaving with an Exacto knife works wonders. Also, I tend to superglue the servo horn to the mount, but not to the servo. Weight = 3g


IN: 1.665 w x 1.665 d x 1.04 h
CM: 4.228 w x 4.228 d x 2.642 h


Sign In or Join to comment.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.