Ball Bearing 6-Sided Die (small)

Design by WillLaPuerta

(0)

0 out of 5
*
*
*
*
*

(3) Comments

Contact Designer

Six sided die with ball bearings (1-6) on each side. With a .25mm clearance around the balls they should all move freely. Slightly smaller version, by request, but I couldn't make it much smaller without getting a little too close to the minimum space needed for moving parts. They're wedged in there pretty tight so you'll need to take some time and break them loose.

cm: 1.69 w x 1.688 d x 1.69 h

in: 0.665 w x 0.665 d x 0.665 h

Comments

You must login to leave a comment

WillLaPuerta says:

Flag as inappropriate

Also, the new Frosted Detail and Frosted Ultra Detail allow a gap of .1 and .05 mm.

April 22, 2011, 3:20 am

WillLaPuerta says:

Flag as inappropriate

Already printed it out and it worked. I had to work at it a bit to get the bearings loose and even had to stick it in the freezer for a bit to get the 6 side to move, but it works just fine. I'd post a picture, but my camera doesn't work very well for something this small. It's . . . oddly satisfying to just sit around and roll the bearings around and around in their tracks.

April 5, 2011, 12:13 am

mctrivia says:

Flag as inappropriate

Cool design but in my experience you need 0.6 to 0.7mm clearance for parts not to get fused(at least in wsf) Let me know if you get this printed and I am wrong as it is really cool.

April 5, 2011, 12:10 am