Finally - an anatomically accurate human skull small enough to be worn as a pendant.
After selling quite a few of my 'two in one'
skulls I realized there are a lot of other fancy skulls out there but not really accurate ones that are affordable.
So I made this design from the same CT-scan data and already optimized it for steel printing, this means making it 2mm thick for printing while hollow it out to keep the cost down.
I kept it as accurate as possible while parts of the mandible and especially the zygomatic arch (cheek bone) needed to be modeled thicker for printing.
It is about 2.5cm high with a 5mm hole on each side, easily fitting Pandora Bracelets.
Now there is the exactly same skull but without the holes for sale here
Remember: It has been successfully printed in WSF but not in Steel yet - might need some minor updates to go through all of Shapeways tests...
If you like a design please add it to your favourites.
If you bought it, leaving even a tiny comment will be very much appreciated and your feedback will help us to improve our products. Thank you for your support !
1.95 w x
2.99 d x
0.768 w x
1.177 d x