Get the best of 3D Printing in your inbox, plus exclusive offers and recommendations from the Shapeways team.
This design is the generic version of my DJI NAZA v2 LED mount.
I have alos done a F450 specific one (see shop)
The LED simply clips into the housing and is held safely. The housing is designed to point downwars at 45 degrees making visibility in flight much better. Anything above knee height can still be seen clearly.
There is a hole that allows access to the LED's micro USB port. Fitment is via velcro through the viarity of slots (see vid)
Included in the kit is also a panel that allows the use of my FO-OSD Hero3 Ring. The panel slides down over the LED and has a hole in it that a Fibre Optic cable slides into (ideally sealed on or hot glued). When used with the FO-OSD ring (sold seperatley) it allows the flyer to see the status LED colour in his/her goggles/screen.
- d3wey -