Open Die (d6) -Design Your Own!

Design by clsn

(2)

5 out of 5
*
*
*
*
*

(1) Comments

Contact Designer

Print in stainless steel

A pipped d6 in the "open" theme, with the raised pips on tilted squares inside a cubical framework.

Customize this die! Send me 1-6 black-and-white drawings (or numbers/words/symbols) to be embossed on the sides of the die, and I''ll put them on for you.

IF YOU WANT TO CUSTOMIZE THIS DIE:

Each side can have EITHER text (up to 3 characters, unicode accepted if I have a font for it) or a graphic symbol on it. If you upload pictures, please make sure they consist of ONLY black and white pixels (no color or grayscale); black will be the foreground (raised). Keep in mind that the drawing area is a square about 11mm on a side, and the resolution of 3D printing is limited. Your picture will be raised 0.7mm above the background (putting it 0.3mm below the level of the outer cube face).

If you provide text, I'll choose a suitable font for it; for complete control over the look make pictures instead. Any faces with no text or image provided will be supplied with pips, or left blank (please tell me which you prefer in the comments)

cm: 1.6 w x 1.6 d x 1.6 h

in: 0.63 w x 0.63 d x 0.63 h