Serleena's Necklace

Serleena's Necklace 3d printed Jewelry Necklaces Rendered image.
Rendered image.
Serleena's Necklace 3d printed Jewelry Necklaces Rendered image.
Serleena's Necklace 3d printed Jewelry Necklaces Rendered image.
Rendered image.
Serleena's Necklace 3d printed Jewelry Necklaces Rendered view from bottom showing curve.
Serleena's Necklace 3d printed Jewelry Necklaces Rendered view from bottom showing curve.
Rendered view from bottom showing curve.
3d Model Viewer
Serleena's Necklace 3d printed Jewelry Necklaces
Serleena's Necklace 3d printed Jewelry Necklaces
Sorry, but I have had to remove this from sale due to printing issues. If you're still interested I do have ONE of these for sale in a gorgeous transparent blue acrylic in my Etsy store for $15 - https://www.etsy.com/listing/80668829/serleenas-necklace-blue-acrylic-14cms

--------------------------------------------------------------------------------------------
A replica of the necklace worn by Serleena in the movie "Men in Black II". This was requested of me a short time ago but in silver, but I've just found out that it is too fragile to make in silver, sorry.

I can't vouch for its likeness since I was shown very indistinct photo's from the movie... but it's a nice necklace anyway, I think. At just over 14cm in width and with a subtle curve to its form it should sit comfortably a few inches below the neck. Your own chain would be required to fasten at each end.
cm: 14.344 w x 0.768 d x 4.164 h
in: 5.647 w x 0.302 d x 1.639 h

Comments

 
@lensman Aww, that sucks.
March 11, 2013, 12:52 pm
@MetasActReon - Thanks, I could make it thicker, but I really wanted it available in silver and the process doesn't seem to allow for that - the model is simply too long and fragile.
March 11, 2013, 10:04 am
That is so cool! If I were you, I'd make it bigger. I am one of many people who would buy it.
March 11, 2013, 1:54 am
 
Not For Sale
Favorited by