Introducing 14k Gold, read more on the blog.

Serleena's Necklace

Serleena's Necklace 3d printed Jewelry Necklaces Rendered image.
Rendered image.
Not For Sale
Sorry, but I have had to remove this from sale due to printing issues. If you're still interested I do have ONE of these for sale in a gorgeous transparent blue acrylic in my Etsy store for $15 - https://www.etsy.com/listing/80668829/serleenas-necklace-blue-acrylic-14cms

--------------------------------------------------------------------------------------------
A replica of the necklace worn by Serleena in the movie "Men in Black II". This was requested of me a short time ago but in silver, but I've just found out that it is too fragile to make in silver, sorry.

I can't vouch for its likeness since I was shown very indistinct photo's from the movie... but it's a nice necklace anyway, I think. At just over 14cm in width and with a subtle curve to its form it should sit comfortably a few inches below the neck. Your own chain would be required to fasten at each end.

Dimensions

IN: 5.647 w x 5.647 d x 5.647 h
CM: 14.344 w x 0.768 d x 4.164 h

Comments

 
@lensman Aww, that sucks.
March 11, 2013, 12:52 pm
@MetasActReon - Thanks, I could make it thicker, but I really wanted it available in silver and the process doesn't seem to allow for that - the model is simply too long and fragile.
March 11, 2013, 10:04 am
That is so cool! If I were you, I'd make it bigger. I am one of many people who would buy it.
March 11, 2013, 1:54 am