Weapon, knowledge, legacy from ancients. This pack including Immobilizor, Polarity Gauntlet, Resonance Blaster & Phase shifter. The Immobilizor spikes could spin. i made a deco sheet for Polarity Gaunlet, print on any transperant piece & bend & place upon the handle like the photo.

Turn your Polarity Gaunlet here: https://dl.dropboxusercontent.com/u/618217/4TFND/PolarityGauntlet_slide.jpg

Optional Clip & 5mm peg for Resonance Blaster & Phase shifter.

Models ve been tested in WSF, un-polished & polished passed. Known issue: You may need to sand a bit the axle of Immobilizer or drill the hole, clear the dust inside to put them together. Please do not force it since the thin parts will break.


IN: 4.214 w x 0.502 d x 1.826 h
CM: 10.704 w x 1.276 d x 4.638 h


Sign In or Join to comment.
Thanks Cnomis. My Gauntlet turned out very well. One last note on the .pdf file you provided relayed from my local copyshop. "If you could center the piece an inch away from the borders of the file they wouldn't need to scale the file because of printer restrictions. That said you could fit 100 of these on a regular A4 size transparant so a couple of extra could never hurt in that file either. thanks for the help!
March 3, 2014, 12:48 pm
@iDarkDesign Oh, would u pls leave ur email address, i will send to u.
February 25, 2014, 3:55 pm
@cnomis Hi, I just recently received this set and was wondering about the size the print should be. I don't own a printer myself but will be using a printshop. So a .pdf would be very helpful. thanks! Rein
February 25, 2014, 2:42 pm
To anyone order or going to install, Please do not force to put the Immobilizer parts together since the thin parts will break. Sanding, drilling or cut out may help. thx for ur concern.
December 16, 2013, 2:33 am


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.