This is an improved version of the Multi Wii 2.0 Pro Hard case. the walls are 1mm thick with 4 x 3mm pegs the board will slip over. The lid has recessed holes to clamp the FC board in place inside the case. The lid will also snap in place for hardware free access. There are 2 mounting holes 45mm holes apart for a 3mm screw to secure it to your quad copter frame. You will need 2 - 3x6mm screws for mounting depending on the thickness of the frame you are using. I've added 4x mounting points 45mm apart to allow for mounting the U Bloc GPS unit directly above the FC board. I will be designing a GPS housing too. This item hasn't been tested yet.
v1.1 - Design complete, reviewing for modifcation.
v1.2 - Model passes print constraints, and has been printed.
v1.3 - First 3D print has been inspected for quality, fit, and function.
v1.4 - Item tested and modifications made if needed.
v1.5 - It has been printed, tested, and adjustments has been made. Items meets design intent and function when printed with default material.
v1.6 and up - modifications to enhance function or additions to design.
Multi Wii Pro 2.0,
5.51 w x
7.368 d x
2.169 w x
2.901 d x