Get the best of 3D Printing in your inbox, plus exclusive offers and recommendations from the Shapeways team.
Longs Peak and Mt. Meeker, known as the Twin Peaks, are two of the most prominent mountains on the Colorado Front Range, and are easily visible from Denver and Longmont. Only Longs Peak is over 14,000', and is the only fourteener in Rocky Mountain National Park. The Rocky Mountains, really a chain of several ranges stretching from Canada to New Mexico, was uplifted between 80 and 55 million years ago, and have been eroded to varying degrees since then. Depending on where you stand, you can be on rocks 3 billion year old, or fresh talus from yesterday's rock fall.
This model features Longs Peak, Mt. Meeker, and Pagoda Mt. summits, but also nearby Mt. Lady Washington and Storm Peak, one on each side of the Boulder Field. The model includes North past Granite Pass and most of Battle Mountain, and to the west Chiefs Head Peak, The Spearhead, Frozen Lake, and Black Lake. On the south side of the mountains, you'll find Snowbank Lake, Keplinger Lake, and the long South face of Meeker down to 10600', including Dragon's Egg Rock. Even with the smallest print, people familiar with the Loft route will notice Ships Prow, Chasm Lake, Lamb's Slide, Loft Couloir, The Beaver and The Notch.
Model scale is 1:75200
Model covers an area approximately 3.5 by 3.5 miles
Altitudes covered: 9958' to 14260'
There is never any vertical exaggeration in TinyMtn models.
TinyMtn models are most affordable in the "Sandstone" and "White Strong and Flexible" materials. This model is in "Sandstone," which is a glued gypsum material. When you receive the model it will be ready for display, though it may smell funny and need some time to air out. "Sandstone" models are much more brittle than "White Strong and Flexible" models, but feel more like light stone. Do not soak it in water, though you can safely seal it with Polycrylic or a similar water-based clear spray sealant. Read more about this popular material here.
These models have been optimized for the above materials, and are not offered in other materials for strength or cost reasons. If you need one in another material, please contact us and we'll try to accommodate your request.
(C) 2013 TinyMtn (TM)
Model created using GDAL, NetPBM, Gmsh, Carve, MeshLab, and other custom software
Source of digital elevation data: U.S. Geological Survey
The USGS home page is http://www.usgs.gov/