Ribbon Microphone. Part 3 the stelframe

Ribbon Microphone. Part 3 the stelframe 3d printed Mechanical parts Music
Ribbon Microphone. Part 3 the stelframe 3d printed Mechanical parts Music Ribbonmicrophone detail
Ribbon Microphone. Part 3 the stelframe 3d printed Mechanical parts Music Ribbonmicrophone detail
Ribbonmicrophone detail
3d Model Viewer
Ribbon Microphone. Part 3 the stelframe 3d printed Mechanical parts Music
Ribbon Microphone. Part 3 the stelframe 3d printed Mechanical parts Music
This is the stelframe of the mic.This part makes it possible to tune the ribbon. To build the microphone you must order the next parts, Part 1 the motorframe, Part 2 the capsule, Part 3 the stelframe and 2 times Part 4 the ribbonplates. These parts ar all 3D printed parts. For making the microphone work you need to a couple of more parts. They are, 2 magnets, 1.8 micron alluminium foil, audiotrafo ( we use the trafo's from BeyerDynamics), a piece of thin copperplate, 1 Neutrik male XLR connector and a couple of 2 and 3 mm nuts and bolds plus some wire. You can look for these parts yourselve our order them at 1818creativesolutions@gmail.com. If you need detaild instructions, have a question please send us a email. We are working hard to finisch our website so you can find all the info there.
cm: 2.4 w x 1 d x 0.7 h
in: 0.945 w x 0.394 d x 0.276 h

Comments

 
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $9.89