Motor Mounts for Multicopter - NoFeet

by MrWhitenoise
  • Black

    Black nylon plastic with a matte finish and slight grainy feel.

Buy Now
a set of 4 Motor Mounts for 25mm Tubes.
for each motor mount you need 4 screws with m2 x 12mm and also a square bolt with 5mm sides.

these mounts are available with large, normal, small and no feet.. you are looking at the version with NO FEET

the mounts include 2 sets of bars that should be superglued onto the tubes where you put the motormount on.
with these bars you can be sure the motor points upwards and wont be able to turn off being vertical.

i allready was flying with these mounts a LOT on my different quadcopters.
they went through many versions and adjustments until i got them as far as they are now.


IN: 2.32 w x 2.986 d x 1.281 h
CM: 5.894 w x 7.584 d x 3.254 h


Sign In or Join to comment.
i normaly use them with 22 mm motors. like t-motor 2208. but also used them with the dualsky xm 4005 dish motors. the holes of the mounts have the typical 16 and 19 mm distance center to center. both options on both directions so you can be sure you can have the cables along the arm direction. not pointing out of the motors sideways.
January 9, 2014, 1:20 pm
What size motor are these rated for?
November 28, 2013, 9:23 pm


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.