AEG Spring Shims (full stroke)

by hunterseeker5
  • White

    White nylon plastic with a matte finish and slight grainy feel.

Buy Now
These spring shims were designed to be placed in the piston body, not over the spring guide, and were intended for the fine tuning of FPS output while adding negligible mass (<2g for the entire set excluding DSG). It should be noted that non-linear springs, DSGs, worn or failing springs, gearboxes of lengths different from the standard V2/3 (compressed/uncompressed), and springs of power levels largely dissimilar to the stated specs will produce different increases in velocity output. Please use these only as a guideline. Please also note that it is very possible to stack too many shims in your gearbox, causing jams or worse component failures. Measuring the minimum compressed length of your spring can be easily accomplished by counting the number of coils, and multiplying it by the thickness of each individual coil. Please note the largest sizes may not fit in 1.5J guns with standard spring lengths, the largest being intended for use with dual sector gear guns only. The following fps increases are estimations for a ~1.5J (400fps) spring: Small -- ~1-4fps; Medium -- ~8-12fps; Large -- ~18-24fps; XLarge -- ~47 fps [CAUTION]; DSG -- ~90fps [CAUTION]


IN: 1.299 w x 2.008 d x 0.472 h
CM: 3.3 w x 5.1 d x 1.2 h


Sign In or Join to comment.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.