Braid Maker

by Marius
Braid Maker 3d printed Close-up of printed BraidMaker
Close-up of printed BraidMaker
  • White

    White nylon plastic with a matte finish and slight grainy feel.

    $16.14
Buy Now
A mechanical device for braiding 3 threads

Dimensions

IN: 2.344 w x 1.109 d x 1.109 h
CM: 5.954 w x 2.818 d x 2.816 h

Comments

Sign In or Join to comment.
 
@Marius Have you thought about placing the drive gear to one side, thereby allowing one of the main gears to drive the other? By the way, there is a type of geneva mechanism that creates alternate, rather than intermittent, motion. I wish I remembered where I found it, as incorporating it into your design would allow the whole thing to be gearless.
July 29, 2013, 9:09 pm
@SteampunkKAJA I think the design would need to be refined as well. Currently the design is symmetrical, which lets it work both ways, but this means that it often jams. If the design was asymmetrical it might run more smoothly. I haven't looked into the best way to make it asymmetrical though.
July 29, 2013, 8:15 am
If you made the clearances smaller and printed this out of ultra detail plastic, do you think it would be possible to motorise this device?
July 29, 2013, 3:22 am
Wow this is clever!
August 19, 2012, 6:43 pm
 
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.