Blazer head

Blazer head 3d printed WSF head installed on toy, after painting with acrylics and sealing.
WSF head installed on toy, after painting with acrylics and sealing.
Blazer head 3d printed Head design pic 1
Blazer head 3d printed Head design pic 1
Head design pic 1
Blazer head 3d printed Head design pic 2
Blazer head 3d printed Head design pic 2
Head design pic 2
3d Model Viewer
Blazer head 3d printed
Blazer head 3d printed
Blazer head 3d printed WSF head installed on toy, after painting with acrylics and sealing.
Blazer head 3d printed WSF head installed on toy, after painting with acrylics and sealing.
WSF head installed on toy, after painting with acrylics and sealing.
Replacement head for robot toy. Dimensions approximately 15mm in all directions, neck ball joint 5mm diameter. Finishing (painting/dyeing etc.) required.
Tags:
head, robot
cm: 1.8 w x 1.584 d x 2.15 h
in: 0.709 w x 0.624 d x 0.846 h

Comments

 
I'm not 100% certain, but I doubt it. I don't have the WFC Soundwave mould, but I believe it's fairly small, even for a Deluxe, and this is geared for a Voyager class figure.
May 23, 2011, 6:55 am
Would this blazer head fit on the WFC soundwave?
May 23, 2011, 2:21 am
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $7.93

Favorited by