Balls for Gridiron Football

Balls for Gridiron Football 3d printed Miniatures Miniatures Over a typical game board, after being cut from the sprue.
Over a typical game board, after being cut from the sprue.
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $9.43

Your opponent has miniatures without magnets? Angry of losing the ball marker? Bored of seeing how the magnets in the bases stick or repeal each other? These balls have a flexible open ring that will keep them around the feet of the miniatures, or you can put them bag style, holding them around the body so the model "carries the ball". No more magnets needed, no more bouncing and rolling balls disappearing.

11-15mm tip-to-tip, 7-8mm diameter, balls for table top games like Impact's Elfball, GW's BloodBowl or Heresy's Deathball. Holder ring diameter 20mm to stay put in most common bases and at the same time be compatible with big miniatures. This sprue holds one model of each of the following 4 types:

- Rugby, spheroid without laces.
- American, laces and pointy ends.
- Australian, smaller laces and indented ends.
- Fantasy, spikes.

Sand and clean the models to fix small "cast" lines and remove any left over material from production. The material is porous, so apply multiple thin coats of primer until it seals. Thinned putty is also a good seal for the balls, but the rings should only get flexible paint (and varnish), preferably in same colour than final surface, for a long lasting look. Paint the rings to match your bases or team colours, with acrylic paint. Brush-on flexible varnish and static grass can mimic the bases' surface too.

Dimensions

IN: 1.968 w x 1.968 d x 1.968 h
CM: 4.998 w x 4.998 d x 1.1 h