Turbolaser Short Turret 1/270

Turbolaser Short Turret 1/270 3d printed SciFi Miniatures
1/270 short turret suitable for capital ship or station armament
cm: 2.874 w x 4.378 d x 2.746 h
in: 1.131 w x 1.724 d x 1.081 h

Comments

 
@Gosric No worries, it was just a thought. Thanks for the information though, once I start working again I may be able to justify the purchase and grab a few. Thanks again
November 14, 2013, 7:03 am
@RoteFlugel Sadly it is hollow. There is unfortunately nothing i can do regarding the price. it is based on shapeways material cost and my markup is literally just a buck or two. They calculate price on amount of material used and even at 1mm wall thickness (minimum safe printing thickness which i use as much as possible) what amounts to a cube in the right scale uses a lot of material. Thank you for liking them though and again, im sorry i cant do anything about the cost
November 11, 2013, 5:35 am
Can a version of this be made hollow. I'm sure these look best in the FD or UFD but cost is too high at that point.. well at least for some of us I'm sure. They look incredible though, very fine detail and just nice to look at. Would look good on a Deathstar Trench run..
November 11, 2013, 4:01 am
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $12.79

Favorited by