I am a fan of these small puck shaped cheese disks so I decided to print a stacking holder for them.
These cheeses come in a pack of 6 so I made this tall enough for that.
My printer was not tall enough to print it in one shot so I divided it into 2 pieces that can easily be glued together.
I originally designed it to hold them with the cellophane in place but after I made it I found my next batch of cheese would not fit as well, there were variations on the cellophane wrapper.
So instead just remove the cellophane and put the bits in with just their wax shell on.
I printed this with a pretty heavy infill of 85%. This made sure it was sturdy and has a little weight to it.
Just print both, assemble as shown, stack cheese inside and pull out one piece at a time from the bottom opening. Babybel Cheese holder
is licensed under the Creative Commons - Attribution - Share Alike
13.868 w x
7.554 d x
5.46 w x
2.974 d x