This extruder carriage has been built for the qu-bd single and dual extruder, but can be used to hold any extruder.
After making this part:
1. Add delrin wheels. Top wheel holes are for eccentric spacers, bottom holes are for 5mm screws. They are sized for Makerslide.
2. Add limit switch ( two small vertical holes)
3. Add belt vise (4 holes in a rectangular pattern) and capture belt.
You will need to change the cutout and drill holes to fit your extruder profile if it is not the qu-bd.
To guarantee that you don't melt the carriage use a piece of 1/8" plywood at the base of the extruder as an insulator from transmitted heat. Ordbot Universal Extruder Carriage
is licensed under the Creative Commons - Attribution - Share Alike
9.3 w x
10 d x
3.661 w x
3.937 d x