Mounting clamp to adapt the Swann Freestyle camera system to my bike's oversize 31mm handlebars
the clamp is oversized by 4mm dia to allow you to wrap handlebar tape or innertube scraps underneath it for a better grip.
Use a 1/4" or smaller bolt to secure the clamp. I intend to make thumbscrews for it in the next iteration and smooth the corners at the clamp side
Align the clamp on your build platform as shown in the preview. Snap off the two small support scraps when done, they are there to make the build cleaner on the mount when using an extrusion printer.
Also noted, video of the camera in use as well as notes on it's inception: davetakespictures.com/wordpress/?p=545&preview=trueHandlebar Clamp for Swann Freestyle or GOPro Camera system
is licensed under the Creative Commons - Attribution
4.532 w x
6.842 d x
1.784 w x
2.694 d x