I made this for usages with my cheap china laser cutter.
You'll need this print and one Pneumatic 12mm-1/4" BSPT male fitting
I printed with to shells just incase. Nozzle down
1. Finish printing and while still hot heat up a fitting of size 12mm-1/4" BSPT
2. Once the fitting is hot it should screw right on. The first i printed was a little to tight so i lite it up quickly and attached a preheated fitting.
3. Seal it and attach as you see fit, FIY. Some casket sealing and some strips might give you a perfect fit.Laser Air Assist Nozzle
is licensed under the Creative Commons - Attribution
2.996 w x
2.992 d x
1.18 w x
1.178 d x