This is a printable extruder plate for the ultimaker.
I really like Jelle's 4 extruder plate, but the local hackspaces do not have a laser capable of cutting the 6mm plywood.
This solves my problem of where to put the second extruder.
I made it a tiny bit wider that the laser cut ones so they will fit a printed extruder.
This sits on top of the far right bearing cap.
You will also need to drill 2 holes in the back of your ultimaker.
4 * 20mm x 3mm screws
2 * 3mm nuts
2 * 3mm washers
cura slicing settings:
.6 wall & top/bottom thickness
I printed this with 30% hexagonal IMPLA from Diamond age. Other wise i would use 60%Printable secondary extruder plate for ultimaker
is licensed under the Creative Commons - Attribution - Share Alike
6.9 w x
4 d x
2.717 w x
1.575 d x