This is a sweet bazooka for the Davincibot.
Which can be found here:
Hot glue a #4 finishing washer to the bazooka, such that the base is facing down. Try to center it as best as possible. I did not create a recess for this washer because I didn't want the accessory to get too thick.
Hot glue a 5mm diameter spherical magnet to the hemispherical recess on the front of the bazooka. Make sure the poles are aligned by placing the magnet in a spare finishing washer while gluing in the magnet.
Stick it on your Davincibot and pretend to blow stuff up!
I have included the openscad file for you to fool with if you wish.
Check out this instructable for more details:instructables.com/id/Davincibots-Create-a-3d-printed-modular-robot-toy/Bazooka for Davincibot
is licensed under the Creative Commons - Attribution - Share Alike
4.094 w x
1.82 d x
1.612 w x
0.717 d x