A touchpoint cap for a Fujitsu T2010 (or similar) laptop/convertible.
My (circa 2007) Fujitsu T2010 has served me well, and continues to do so; however it suffers by having a "touchpoint" mouse (one of the joystick style ones). I managed to lose the replacement caps, and the one I had on there eventually disintegrated after a couple of years of very heavy use.
After searching high and low for several years, I now have a 3d printer and decided to make my own.
Print and attach. I used a little blu-tac around the edge (a little fiddly) because the hole was a little large in my print (0.1-0.2mm) and it wobbled a bit. The upshot is that it's a little "softer" when you press it.
I now have a working mouse again! Fujistu touchpoint
is licensed under the Creative Commons - Attribution - Share Alike
0.8 w x
0.5 d x
0.315 w x
0.197 d x