This thing is a bracket to attach a crew to the z-axis motor mount of the robo3D to facilitate fine adjustment of the z-axis home position.
It is actually a remix to a mod posted by another Robo3D forum member, Cambo3D. Here is the link to the oritingal mod.
The original mod is a great idea, but I wanted to avoid drilling into the injection molded part, so I created a bracket to use the same concept without permanently altering anything.
-Screw 6-32 2" lg screw into hole. If you have a 6-32 tap, you may want to tap it first, but not absolutely necessary.
-mount to lower right corner motor mount (may need to acquire a longer screw depending on what your machine shipped with)
-Push z-axis limit switch bracket down to the rod mounts and turn by about 45 degrees
-Fasten bracket to lower right corner motor mount screw
-Install 6-32X2" screw.
-Adjust as needed to get a correct gap between the nozzle and the bed. Robo 3D Z-Axis Limit Switch Fine Adjustment
is licensed under the Creative Commons - Attribution