A Tritium Pendant

A Tritium Pendant 3d printed Jewelry Pendants Pendant made of Polished Gold Steel w/ red vial
Pendant made of Polished Gold Steel w/ red vial
A Tritium Pendant 3d printed Jewelry Pendants Pendant made of Polished Gold Steel w/ red vial
A Tritium Pendant 3d printed Jewelry Pendants Pendant made of Polished Gold Steel w/ red vial
Pendant made of Polished Gold Steel w/ red vial
A Tritium Pendant 3d printed Jewelry Pendants Pendant with green vial.
A Tritium Pendant 3d printed Jewelry Pendants Pendant with green vial.
Pendant with green vial.
3d Model Viewer
A Tritium Pendant 3d printed Jewelry Pendants
A Tritium Pendant 3d printed Jewelry Pendants
A Tritium Pendant 3d printed Jewelry Pendants Pendant made of stainless steel
A Tritium Pendant 3d printed Jewelry Pendants Pendant made of stainless steel
Pendant made of stainless steel
A Tritium Pendant 3d printed Jewelry Pendants Pendant made of Polished Brass
A Tritium Pendant 3d printed Jewelry Pendants Pendant made of Polished Brass
Pendant made of Polished Brass
It is intended to mount a 3 x 25mm Tritium vial in this neck pendant. The assembly is preferably done with a transparent adhesive as Norland or other high-quality adhesive. The hole for the chain is about 2.8 mm, which is on the low side for some necklaces to fit through. Please verify that the intended chain fits this hole.
cm: 0.602 w x 0.602 d x 3.212 h
in: 0.237 w x 0.237 d x 1.265 h

Comments

 
Vials that fit can easiest be found on Ebay.com
November 26, 2013, 7:10 pm
@Jyhwang the vial should be 3x25 mm for best look, and it have to be glued otherwise it will fall out. The hole is made a bit bigger so differences in printing can be accepted.
November 26, 2013, 7:09 pm
@Jane_S what tritium vial do you recommend? And why is adhesive is needed - could we just put the vial in? This is gorgeous!
November 26, 2013, 3:15 pm
 
  • Stainless Steel

    Bronze-infused stainless steel with visible print lines and rough feel.

    $22.77

Favorited by