Raspberry Pi CASE 1.0 NO LOGO

by MarcoA
  • White

    White nylon plastic with a matte finish and slight grainy feel.

    $38.62
Buy Now
The same case as "Raspberry Pi CASE 1.0" (http://shpws.me/ooGN) but without the Raspberry Pi logo on top. You can apply your own sticky logo (27.5 x 27.5 mm, R5 rounded square) in the center. Features: - snap-fit fixing system for the board, easy to mount/unmount; - snap-fit closing system, no screw required; - bottom holes for blocking the computer by screws (sliding mount); - led lightguides (not included in this model, available here: http://shpws.me/6yFP ); - pre-shaped hole for GPIO access, just cut it out to open. In this page you can find a gallery of shots working cases by enthusiast users! http://marcoalici.wordpress.com/raspberry-pi-case-gallery/

Dimensions

IN: 3.709 w x 2.45 d x 1.339 h
CM: 9.422 w x 6.222 d x 3.4 h

Comments

Sign In or Join to comment.
 
 
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.