Introducing 14k Gold, read more on the blog.

Detail Test, Metric

  • White

    White nylon plastic with a matte finish and slight grainy feel.

    $4.07

This is a model used to test printing detail of various materials. To see a detailed key and a high resolution example printed in Stainless Steel, visit http://www.thefrankes.com/wp/?p=2138. This object is tiny and includes many details in the 0.0 to 1.0mm range; it many not print in all materials, but I've made it available in all in case you want to try.

Dimensions

IN: 0.727 w x 0.727 d x 0.727 h
CM: 1.846 w x 1 d x 0.324 h

Comments

 
This might come in handy. I'm printing really tiny things, and I might need to experiment with different material. I found that I can't make a peg that it less than 2mm, it turns out flat.
February 29, 2012, 1:24 am
Thanks for your comments! Yes, it's steel; I know when it's shot that close-up it's really hard to tell what the material is... I didn't think the descriptions would be legible if scaled down on this site, but I can try when I get back into town in a few days.
July 9, 2010, 1:31 pm
I've Just found the descrition with all the measurements to this little thingie on your blog. Why not put it under the pictures here?
July 9, 2010, 12:09 pm
These rings are very useful for estimation of printable slot-width. Even from the picture! Thanks. The photos are steel right?
July 9, 2010, 11:58 am