British Shako

British Shako 3d printed Figurines
British Shako 3d printed Figurines Description
British Shako 3d printed Figurines Description
Description
3d Model Viewer
British Shako 3d printed Figurines
British Shako 3d printed Figurines
This hat can be used as custom item for Minifigs. It's modelled according to drawings of British Infantry units of the Napoleonic area. Since also other units of this time were using this "Ofenrohr" design it can be used for German, Dutch, Austrian or other nations.
In difference to the original Minifig piece there's a plume at the top of the hat.

Take also a look at the much cheaper packs section or ask for one if it's not available.
cm: 1.23 w x 1.406 d x 1.176 h
in: 0.484 w x 0.554 d x 0.463 h

Comments

 
Yeaaah it works. See the picture above.
January 19, 2009, 8:46 pm
Prototype is already ordered. Expect a review and pixtures with mid of January ...
January 7, 2009, 8:11 pm
Prototype is already ordered. Expect a review and pixtures with mid of January ...
January 7, 2009, 8:11 pm
This item was the principle mother of all designs since the lack of original shakos was a big problem in the community. I decided to start with an alternative design (see french shako) to bring an alternative which was widely used by many nations. Currently the new pirate series is launches which should overcome the above given problem. But nevertheless this desigtn can be used as base for many others. Suggestions are welcome !!
January 6, 2009, 2:32 pm
 
  • White Strong & Flexible Polished

    White nylon plastic polished to reveal a smooth matte finish.

    $3.44