PET Bottle Opener

PET Bottle Opener 3d printed Mechanical parts Maker/DIY
If you homebrew and use PET plastic bottles I'm sure you noticed that after bottling and tightening 40+ bottles your hand gets pretty sore. This aid fits perfectly over a PET bottle cap and will enhance the torque needed to tighten these bottles, eliminating that problem, and doubles as a good aid to remove the caps when you are ready to drink them.
cm: 11.988 w x 6.218 d x 1 h
in: 4.72 w x 2.448 d x 0.394 h

Comments

 
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $38.65