Icodie (3 cm) v.4

Design by opresco

(24)

4.75 out of 5
*
*
*
*
*

(8) Comments

Contact Designer

Description

Description

• 20 faceted dice (based on the icosahedron) • Could be worn as a pendant • Lanyard not included.•
Uses the same original construction algorithm as the popular DODCLOCK DIE and the 32-BIT SOCCER BALL DIE
See my New Spring Loaded Dice:
Spring-loaded 30-sided die.
Spring-loaded Icodie.
Spring-loaded die.

cm: 2.848 w x 2.848 d x 2.85 h

in: 1.121 w x 1.121 d x 1.122 h

Comments

You must login to leave a comment

HillyOTM says:

Flag as inappropriate

I bought this recently, but, while i like way it looks and feels, it wasn't practical in the game I had today. The gaps between the sides result in the die landing between two numbers more than half the time. Also some of the numbering isn't very clear, 18 and 19 look very similar. I think it's a nice die ornamentally, but just isn't very playable.

February 6, 2013, 11:49 pm

opresco says:

Flag as inappropriate

hai jorlack, ovidiu was passed away. thanx for your tip.... mihnea

December 28, 2012, 5:55 pm

Jorlack says:

Flag as inappropriate

Sorry copy past from another dice post of mine. Still applies but you don't have the 20-1 or 10-11 either.

December 28, 2012, 4:08 am

Jorlack says:

Flag as inappropriate

Looks good but its not game legal. Opposite faces should equal max die value +1 Thats why 1 is opposite of 20 and 10 is opposite of 11 (you do have those 2 sets right but the rest of your numbers are off.) Same formula applies to all dice. Or you can spiral the numbers around it in sequence for a life counter.

December 28, 2012, 4:07 am

Smoothsmith says:

Flag as inappropriate

This is really cool, it's a shame you don't have all the die sizes(4, 6, 8, 10, 12, 00) in this design or I'd probably buy them ^^

November 28, 2012, 3:37 pm

opresco says:

Flag as inappropriate

Kevin, I guess you are :) and guess what? Maartje Vijn sent me a letter today informing that walls still not OK! So I revised the walls again, for the second time!; I believe they are now thick enough to be printed in concrete and/or Gold Plated Stainless Steel :) I don't mind doing this at all because this is also an opportunity for me to improve the design; in this particular case, I got rid of the central sphere and let the triangular columns meet neatly in the center; hope you like/enjoy this revised design better; I thank you again for your interest and apologize to you a second time and hopefully a last time :)

May 25, 2010, 5:43 pm