The Long-Bar Tool

The Long-Bar Tool 3d printed Keychains Maker/DIY
I present the Long-Bar hex bit driver tool, another commissioned piece for JLara.

It's features include:
A prying tip,
An in-line 1/4" hex bit driver,
2 more 1/4" wrench or hex bit drive points,
Various other wrench sizes:
    2.5mm,
    3.2mm,
    4mm,
    3/16",
    5mm,
    5.5mm,
    8mm (5/16"),
    10mm,
    7/16" (11mm),
    13mm (1/2"),
    9/16" (14mm),
    16mm (5/8"),
    11/16",
Storage space for two 25mm long 1/4" hex bits in the handle and two more in the central cut-out, depending on the type of driver tip.

This tool requires nine o-rings, in two different sizes to secure various hex bits in place:
Two to retain a hex bit into the in-line driver at the prying end (9mm ID, 2.5mm diameter, not included).
Four to secure the two hex bits into the storage slots (6mm ID, 2mm diameter, not included).
Three more to hold another two hex bits into the central cut-out (9mm ID, 2.5mm diameter, not included).

This model is designed to be printed in Stainless Steel or one of it's variants.
Although all care has been taken to ensure this model is correctly sized, due to variations in the printing process, some filing may be required to ensure correct fitment of some of the hexes.

The Long-Bar can be secured to a keychain or lanyard with a No.2 McGizmo clip, similar 25mm gate clip or small split ring through the 1/4" hex hole at the top of the tool or the small hole in the prying edge..

There are some more photos of this object and other examples of my work, both 3D printed and otherwise, on my 'Tofty' facebook page
cm: 13.208 w x 3.296 d x 0.332 h
in: 5.2 w x 1.298 d x 0.131 h

Comments

 
 
  • Stainless Steel

    Bronze-infused stainless steel with visible print lines and rough feel.

    $64.28

Favorited by