Explorer One Revisted

Explorer One Revisted 3d printed SciFi Vehicles
Explorer One Revisted 3d printed SciFi Vehicles Showing the AE-35 Antenna Thinned Down
Explorer One Revisted 3d printed SciFi Vehicles Showing the AE-35 Antenna Thinned Down
Showing the AE-35 Antenna Thinned Down
3d Model Viewer
Explorer One Revisted 3d printed SciFi Vehicles
Explorer One Revisted 3d printed SciFi Vehicles
Ok folks due to some issues that have happened lately. And due to some new "guidelines" from ShapeWays. I sat down and went over this model with a very good 3D modeler and friend, to do some repairs to the details and really attempt to make this the best model this could be. The pod bay doors are now down in the command module by 1mm, with raised door details that are correct. The command module now has bars showing the windows, so now they can be detailed better. The side entry hatch is now also down in the command module, instead of sitting on the surface. All these new details go along with the corrections I did to the AE-35 Antenna complex that everyone wanted. And the smoothed out command module that I did. Sadly however one side effect. ShapeWays new guidelines for escape holes on hollow models now requires that where a single escape hole is used, that it be 4mm in diameter. That means you are going to make a plug for the holes, before being able to mount it. This model is 1/1000 scale. Using the side entry hatch on the port side as a base line for scaling. I hope these new changes are what everyone wanted. Please let me do a test print before ordering this. Please.
cm: 1.766 w x 16.214 d x 2.324 h
in: 0.695 w x 6.383 d x 0.915 h

Comments

 
@siddharta60 I thought you should see that your efforts haven't been ignored. This new design is a direct result of what happened to you. I hope you can see fit to give my shop another chance.
April 9, 2014, 6:04 pm
Thank you for cooperation and friendness!
March 2, 2014, 6:52 pm
@siddharta60 Turns out from the numbers you gave me, it is. As a result I am shutting down FD & FUD materials for this model until we can contact ShapeWays about them sending out bad production models to people. This makes me and my 2 friends here @TheVerse look bad, and we are going to have to find out what is going on and why. Please accept my sincere apologies for this. Thank you however for bringing this to our attention. I personally will keep you informed of what we find out.
March 2, 2014, 6:44 pm
After investigation, it turned out that the model I received WAS NOT made by Mechanoid !!!!!
March 1, 2014, 9:19 am
@siddharta60 I have posted the renders that I sent you. So everyone can see the details are there. Something happened during printing that I have no control over. I am very concerned about what happened to you. Maybe you should contact the Service Team and see if they can find a way to print you a replacement. Because the Pod Bay Doors are there. They are a bit deeper and the ring more defined.
February 28, 2014, 8:22 pm
Yes. FD
February 28, 2014, 7:59 pm
@Mechanoid Ok! Thank you
February 28, 2014, 7:10 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $11.04

Favorited by