Tritium Lantern 2D (stainless steel)

Tritium Lantern 2D (stainless steel) 3d printed Keychains Pendants
I present version 2D of my keychain tritium lantern for use with a 3x22.5mm tritium vial (tritium vial not included) and does not require a clear tube like my first version.

The attachment hole is 2mm wide and is perfect for a 10mm split ring (not included).

The tritium vial should be set using a UV activated optically clear adhesive such as Norland 61 or Loctite glass bond. These adhesives will cure in direct sunlight in an hour or so.

Due to potential irregularities in the stainless steel printing process some drilling may be required on the lanyard hole and tritium vial channel to ensure correct fit but probably not.

I have a few assembled tritium lanterns in stainless steel available from my Etsy shop (tritium vial glued in place with Norland 61 and split ring installed).

There are some more photos of this object and other examples of my work, both 3D printed and otherwise, on my 'Tofty' facebook page.
cm: 0.676 w x 3.068 d x 0.676 h
in: 0.266 w x 1.208 d x 0.266 h

Comments

 
 
  • Stainless Steel

    Bronze-infused stainless steel with visible print lines and rough feel.

    $11.49