Crossfire Hands (Aqua variant)

Crossfire Hands (Aqua variant) 3d printed Toys
Version 1.0

This is the Aqua variant of the Crossfire hands design which features large spike which slides on to the back coverplates. These hands are fully posable; all fingers and thumbs are double jointed. The wrist connects to the forearm via a 5mm port.

Length is 36mm from wrist to tip, 24mm across the knuckles.

This variant is untested. Strong Flexible material is recommended.
Tags:
Toys, hands
cm: 10.05 w x 5.286 d x 1.828 h
in: 3.957 w x 2.081 d x 0.72 h

Comments

 
@fakebusker83@ yes! I'm very happy with your design!
June 25, 2013, 2:11 pm
Hi @BrownAdept , yes, the dye doesn't seep in deep into the material, so you will see white when you cut the sprue or sand it. You will have to touch them up unfortunately. Besides that, I hope everything else is working well?
June 25, 2013, 1:55 pm
I did'nt know the purple was just a coating. So each of the "Flash spots" has a white dot. Some of the pieces needed a little sanding. Again, I think due to the purple coating. I recommend ordering in white. Really cool looking! I will try to get and image to Ariel soon.
June 25, 2013, 1:39 pm
I ordered them in purple. I think I'm going to paint the figure up in sharkticon colors but I want to see how the purple hands look with the original colors. Can't wait for them to get here!
June 11, 2013, 2:49 pm
@fakebusker83 nice and fast too
June 9, 2013, 10:44 pm
@formlessdraon27 Oh pretty recently. It was done as a quick request :)
June 9, 2013, 10:31 pm
nice work when did u made this upgrade ?
June 9, 2013, 8:50 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $19.00

Favorited by