1/200 JN-129 Front Tracks and Armament

1/200 JN-129 Front Tracks and Armament 3d printed Miniatures Vehicles If you are on an airship, this is a sight to fear: the guns of the JN-129 trained on your vessel. Those unfortunate enough to be above and in front of the tank can expect a barrage from all six guns.
If you are on an airship, this is a sight to fear: the guns of the JN-129 trained on your vessel. Those unfortunate enough to be above and in front of the tank can expect a barrage from all six guns.
1/200 JN-129 Front Tracks and Armament 3d printed Miniatures Vehicles
1/200 JN-129 Front Tracks and Armament 3d printed Miniatures Vehicles
1/200 JN-129 Front Tracks and Armament 3d printed Miniatures Vehicles If you are on an airship, this is a sight to fear: the guns of the JN-129 trained on your vessel. Those unfortunate enough to be above and in front of the tank can expect a barrage from all six guns.
1/200 JN-129 Front Tracks and Armament 3d printed Miniatures Vehicles If you are on an airship, this is a sight to fear: the guns of the JN-129 trained on your vessel. Those unfortunate enough to be above and in front of the tank can expect a barrage from all six guns.
If you are on an airship, this is a sight to fear: the guns of the JN-129 trained on your vessel. Those unfortunate enough to be above and in front of the tank can expect a barrage from all six guns.
3d Model Viewer
1/200 JN-129 Front Tracks and Armament 3d printed Miniatures Vehicles
1/200 JN-129 Front Tracks and Armament 3d printed Miniatures Vehicles
The front tracks and weapons of the JN-129. Each of the five smaller turrets is armed with a 90-mm gun and will fit in my KV-chassis like all my other tank turrets (though I don't see anyone doing that). The large turret will fit only in the JN-129 hull and is armed with a 250-mm main gun. Please note when assembling that the drive wheels are in the centre of the tank - therefore the two sets of tracks are not pointing in the same direction, they are facing each other. In addition, there is nothing to keep the front section from falling out if you pick the model up save the tight fit of the mating surfaces. I will probably add a key-type retainer in the near future.
cm: 8.06 w x 6.906 d x 1.7 h
in: 3.173 w x 2.719 d x 0.669 h

Comments

 
 
Not For Sale