Pitch And Roll Brushless Conversion Kit For Freefl

Pitch And Roll Brushless Conversion Kit For Freefl 3d printed Mechanical parts Robotics
This is the Brushless Conversion mount kit for the Freefly 2 axis/3 axis Gimbal. 1. Aside from this kit you will need an assortment of M3 (different lengths) Stainless Allen Key bolts and nuts. 2. 2x Brushless motors from www.funtobuyonline.com link is: http://www.funtobuyonline.com/brushless-motors/ipower-gimbal-brushless-motor-gbm5208-150.html These are rated to 2000g payload (although they recently changed there description to 1500g for what reason I don't know). 3. 1 or 2 Martinez boards. Se here: http://www.unmannedtechshop.co.uk/2-axis-brushless-gimbal-controller.html Reason why up to two is that with one you get excellent stability but if you want to input an RC signal to the pitch control and point the camera 90 degrees down you will need another board with another gyro mounted soley on the roll axis. 4. Naturally a 2 or 3 Axis FreeFly System Gimbal (will not fit anything else.) 5. Some slight DIY skills, although you will not need to cut, break or drill your gimbal to fit this kit. Worst case if you need to go back to the Servos or previous setup you can. 6. Be prepared that when a 3D print is made sometimes the holes and fits maybe a little tight or loose. This just means you may need to rub/sand or drill some parts to make them fit snuggly :) 7. Contact me for the 3rd axis conversion although not made the board fitting yet.

cm: 16.542 w x 24.748 d x 6.49 h
in: 6.513 w x 9.743 d x 2.555 h

Comments

 
I ordered this kit sometimes ago and never had time until now to mount and tune. Finally done, and I have to say that it's a really great conversion kit! It needs some DIY skills, but nothing impossible. Thanks for your work!
November 17, 2013, 12:06 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $254.85

Favorited by