Fuji X mount double lens cap

Fuji X mount double lens cap 3d printed Accessories Gadgets
Fuji X mount double ended lens cap. I've been wanting a double lens cap for my Fuji but no one made it, so I just designed it and had it printed at Shapeways. I'm very happy with it... I was often changing these two lens and switching the caps with both of these small lenses in one hand.
cm: 5.462 w x 5.462 d x 2.54 h
in: 2.15 w x 2.15 d x 1 h

Comments

 
You'd either have to wrap it in light restricting opaque tape, or cast it in black plastic.
December 29, 2013, 10:50 pm
@Donald_Pelton The other end would need to be the opposite (camera mount vs lens mount). And the strong white material isn't light tight, so it would need additional post work too.
December 29, 2013, 10:44 pm
All you'd need to do that would be to eliminate the wall in the center, and you would have a macrophotography close up adapter.
December 29, 2013, 10:38 pm
@Donald_Pelton Yes, that could be done or a reverse mount to flip the lens for extreme close ups.
December 29, 2013, 7:23 pm
@duann Thanks Duann!
December 29, 2013, 7:17 pm
Another idea I thought of would be to make a ring that would extend the length between lenses for macrophotography.
December 28, 2013, 6:42 pm
This is a great idea, I saw it on Instagram and had to share it on the Shapeways blog. http://www.shapeways.com/blog/archives/2106-3D-Printing-Connection-Storage-Fuji-X-Mount-Double-Lens-Cap.html Well done.
June 10, 2013, 2:11 pm
 
  • White Strong & Flexible Polished

    White nylon plastic polished to reveal a smooth matte finish.

    $28.00

Favorited by