Möbius Snake Bracelet (Small)

Design by WelshDesigns

(8)

5 out of 5
*
*
*
*
*

(4) Comments

Contact Designer

stainless

snake

cross section

stainless

All Render

End view

Stainless steel test print

Gray Background

Black Background

Inspired from the classic Möbius Strip, this design has a small "snake" that travels the path along the outside, then inside, and back again, helping illustrate the concept. The inside diameter is about 2.7 inches. Go view a video I made of the test section I just received in Stainless Steel. http://www.youtube.com/watch?v=vIEXeOSeG-8 There is a modification I need to make before it will work in steel, but the other materials should print just fine. the way the steel is finished ended up sort of welding the snake to the bracelet! :)

Please note, there is a larger version in my shop now too. The large is about 3.0 in inside diameter.

cm: 8.34 w x 1.016 d x 8.438 h

in: 3.283 w x 0.4 d x 3.322 h

Comments

You must login to leave a comment

WelshDesigns says:

Flag as inappropriate

I got my Stainless Steel test print back and it looked great. Check it out working here. http://www.youtube.com/watch?v=vIEXeOSeG-8 There is a technical issue with printing in Stainless though, so I have pulled it an Alumide from the available materials until a solution can be found. But meanwhile the others materials should be fine becasue they are printed (ie supported during printing) in a different way and won't be affected by the technical issue the same way metals are.

May 18, 2010, 3:42 pm

WelshDesigns says:

Flag as inappropriate

I'm printing now, I'll post pics when I get it back.

April 23, 2010, 4:42 pm