MintyBoost Box

MintyBoost Box 3d printed Cases Maker/DIY
This is a custom enclosure for the Adafruit MintyBoost USB Charger. I wanted to add an on/off switch and storage for a USB cable which the original Altoids can didn't allow. The box is designed to fit a Radio Shack switch #275-0409 and a shorty micro USB cable which I got from NewEgg #N82E16812705131. Use M2 or #2 screws for the switch - it will be a bit of a pain due to space constraints so install it before the board and batteries. The board will need the foamy double-sided tape (which comes with MintyBoost) to install at the correct height for the USB hole.
cm: 9.674 w x 9.208 d x 2.482 h
in: 3.809 w x 3.625 d x 0.977 h

Comments

 
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $40.00