HK Alignment Tool V3.1

HK Alignment Tool V3.1 3d printed Mechanical parts
HK Alignment Tool V3.1 3d printed Mechanical parts
HK Alignment Tool V3.1 3d printed Mechanical parts
HK Alignment Tool V3.1 3d printed Mechanical parts HK Alignment Tool V3.1
HK Alignment Tool V3.1 3d printed Mechanical parts HK Alignment Tool V3.1
HK Alignment Tool V3.1
3d Model Viewer
HK Alignment Tool V3.1 3d printed Mechanical parts
HK Alignment Tool V3.1 3d printed Mechanical parts
This is a replica of the cartridge alignment tool that was provided with Harman Kardon linear tracking turntables. This tool is intended for use with the Rabco arm wands on ST-5, ST-6, ST-7 and ST-8 models. Please exercise care when using this item so as not to damage your stylus assembly. Please note the following: 1/ This model is based on information posted on AK forums rather than measurements made by myself using an original alignment tool. 2/ There may be some minor dimensional variations caused by the printing process which is outside of my control. As a result, this tool should not be considered to be an exact copy of the original. If you find this product useful, please consider becoming a subscriber to the Audiokarma forum which makes all of this possible.
cm: 8.662 w x 2.342 d x 2.222 h
in: 3.41 w x 0.922 d x 0.875 h

Comments

 
Great work! The measurements are spot on and it makes setting up any suitable cartridge a snap. A time saver for sure, any HK/Rabco ST series table owner should own! I highly recommend it! Rick Read
August 20, 2013, 12:43 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $15.00

Favorited by