HeatLock (iPhone 4/4S)

HeatLock (iPhone 4/4S) 3d printed Gadgets Cases

The first 3D Printed iPhone 4/4S Bumper designed to account for differences in outside temperatures that can make other 3D printed bumpers looser and tighter.

HeatLock is designed to be too small for your iPhone 4/4S, which may sound strange, but is actually a revolutionary concept. As the bumper gets hotter, the plastic nylon it is made out of will expand, causing the bumper to get bigger. If the bumper starts too small for the phone, you could heat it up enough to get the case on, then as it cools it will fit perfectly.

When your case arrives simply heat it up with a blow dryer or heat gun for a few seconds to expand the plastic. Slip the case on and allow a few minutes for it to cool off. The case should shrink down so that it is snug to your phone.

Prototyping is complete! Model will fit very snug on an iPhone 4/4S after heating!


Using your bumper:
1. Unpack from box
2. Heat corners of bumper
3. Stretch onto iPhone
4. Keep heating and stretching until bumper fits
5. Enjoy!

To undo case, reverse process. iPhone will not be damaged by added heat; however, Shapeways nor SolidWorks Tech Designs assumes responsibility for any damage done to your iPhone.



Heat Resistance Guide for Materials :
White Strong and Flexible or Colored : 176 Degrees F
White or Black Detail : 118.4 Degrees F
Frosted Plastics : 176 Degrees F


cm: 6.17 w x 11.87 d x 1.01 h
in: 2.429 w x 4.673 d x 0.398 h

Comments

 
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $12.75