Tritium Lantern 1A (stainless steel)

Tritium Lantern 1A (stainless steel) 3d printed Keychains Pendants
This is a small keychain tritium lantern for use with a 3x22.5mm tritium vial (tritium vial not included).
This model has been scaled for printing in stainless steel.

As well as the tritium vial, a clear plastic spacer tube is required to fill the void between the tritium vial and inner wall of the holder body (not included).
The tube's dimensions should be around: 21mm long, 6mm OD, 3.1mm ID (due to the varying final dimensions of different materials the tube dimensions are approximate and may need adjusting).
The attachment hole is 2mm wide and is perfect for a 10mm split ring (not included).

The tritium vial and clear spacer tube should be set using a UV activated optically clear adhesive such as Norland 61 or Loctite glass bond. These adhesives will cure in direct sunlight in an hour or so.

Due to potential irregularities in the stainless steel printing process some drilling may be required on the lanyard hole and tritium vial channel to ensure correct fit.

I have a few assembled tritium lanterns in stainless steel available from my Etsy shop (tritium vial glued in place with Norland 61 and split ring installed).

There are some more photos of this object and other examples of my work, both 3D printed and otherwise, on my 'Tofty' facebook page.
cm: 0.848 w x 3.18 d x 0.848 h
in: 0.334 w x 1.252 d x 0.334 h

Comments

 
 
  • Stainless Steel

    Bronze-infused stainless steel with visible print lines and rough feel.

    $11.77