Bead D designed for Tyler.
It accepts two of the 2x6mm tritium vials (tritium vials not included).
The base hole is designed to take two strands of 550 paracord.
This model is sized for printing in stainless steel, however it will still work in all materials that have been made available.
This listing is for the newer 'hole' type bead, for the older 'pin' type bead please see my other listings.
The tritium vials should be set using a UV activated optically clear adhesive such as Norland 61 or Loctite glass bond. These adhesives will cure in direct sunlight in an hour or so.
1.154 w x
0.832 d x
0.454 w x
0.328 d x