Arkham City Batarang

Arkham City Batarang 3d printed Gadgets Toys
Arkham City Batarang
cm: 18.238 w x 6.336 d x 0.864 h
in: 7.18 w x 2.494 d x 0.34 h

Comments

 
is this full size?
February 19, 2014, 9:52 pm
@AwesomenessPrime There are 3 pieces that being the two wings and the center piece. What the wings do is snap into place and being tight enough not to fall out but still lose enough to rotate. When I printed mine the wing were a very good fit they did come a bit loose over time but a small dab of superglue or cement glue fixed that right away and it has held up every since. If you have any questions feel free to ask, and thanks for taking interest in my design.
September 5, 2013, 2:08 am
Thanks for the reply! :) So this batarang can't rotate on a general principal?
September 4, 2013, 1:31 pm
@AwesomenessPrime yes you might have to use some superglue but after that it holds very well I had one printed back in December and I used a dab of super glue and its held perfectly thus far
September 3, 2013, 1:59 pm
Just seeking some reassurance here, but how does this stay together?
September 3, 2013, 12:25 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $29.00

Favorited by