Mirror Holder 1° angle

Mirror Holder 1° angle 3d printed Mechanical parts
This is actually a holder for 8 rotating mirrors for a laser scanning display project. UPDATE 04/11/2013 I have uploaded the proper model fixed by Mr. Stony Smith ( http://www.shapeways.com/shops/stonysmith - his designs are a-ma-zing, check them out!) so if you're ordering it after 04/11/2013 (reading this as April 11th, 2013 :) ) it should print as intended. --------------------------------------------- This part actually prints as two separate parts, so it's most likely going to be re-done very soon, as soon as I figure out how to prevent the separation of the base disk from the cylinder (they are joined in my 3D model). But if you need it in a hurry, you're going to have to glue the two parts together to make it work.
cm: 5.996 w x 6 d x 1.6 h
in: 2.361 w x 2.362 d x 0.63 h

Comments

 
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $14.40