Groove Cutter rev. 2 (10+anti-rotation jig)

by hunterseeker5
  • White

    White nylon plastic with a matte finish and slight grainy feel.

Buy Now
These bore groove cutters can be applied in a variety of ways to produce a variety of experimental effects. --- Perhaps the most promising is outlined in this product's image, whereby twin grooves applied to the base of the bore would provide upward force against the bb further enhancing the existing bore dynamic of the bb riding on the ceiling. --- Alternate application of this can be used for single ceiling grooves, or up to six evenly spaced full length or partial length (crown) bore grooves. When cutting less than three grooves at a time it is advisable to apply abrasive to only the panels intended to cut. --- The anti-rotation jig on this model contains an alignment ridge which fits into the slot at the base of most barrels thus easily aligning it with vertical. Removal of this ridge, or the purchase of the separate standard alignment jig, will be necessary to use the alignment jig at the muzzle end of the barrel or on barrels without an external alignment channel. --- For rapid cutting it is possible to apply a high viscosity CA to the desired panels, and then dip them in a coarse abrasive. This allows radically faster cutting than traditional non-bonded abrasives. --- THIS GEN OF THE PRODUCT HAS NOT YET BEEN TESTED. THE CONCEPTS HEREIN ARE PURELY EXPERIMENTAL.


IN: 1.976 w x 3.185 d x 0.417 h
CM: 5.018 w x 8.09 d x 1.058 h


Sign In or Join to comment.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.