Gyrocam servo gear for Hitec HS-425BB servo

Gyrocam lens gear for Contour Roam camera

Custom pedal design. Should fit on a standard pedal skeleton. I've prototyped this on Sandstone but it should be made from metal. I'm including sa...

Part to be used as support for the light foam wheel. - part of the quadcopter frame (under development)

Gyrocam rail mount for Contour Roam camera

Gear 36 teeth, pitch radius 18mm

This is meant to hold our pleats without drilling into the window frame. Not yet tested if it's strong enough.

Finally the official release of the SkyLight SBG Digital Brushless Gimbal for GoPro Hero 2 HD Cameras!! Designed for the AlexMos SImple Brushless ...

Audi Hazard Trim Latch by MatthewLaBerge

5-spoke 52mm RC Car rim

3-Blatt Prop-Halter für EPP1045. Propellerachsen haben einen Durchmesservon oben 5mm, unten 4mm, um noch ein M5 Gewinde reinschneiden zu k&ou...

A connection piece to be used between the oversize clamp and Busch & Müller Ixon Bicycle Headlights. It's modeled based on the original part, but ...

Part of a wire leg for a multirotor. Each leg needs two hinges. It is held to 1/2" (13mm) square arm with two zip ties. The hinge either holds the ...

2-Blatt Prop-Halter für EPP1045. Propellerachsen haben einen Durchmesservon oben 5mm, unten 4mm, um noch ein M5 Gewinde reinschneiden zu k&oum...

This is a Sheet Set for a Hollow Mini Mendel. Parts were made hollow to cut down on cost of printing. Just fill them with some sort of epoxy resin ...

feeder support for 8mm axis see OPENPNP project

Proportional Mixup was suggested by Alex Polonsky. The puzzle is a shape-mod of the Mixup Cube. By having rhombicuboctahedron-shaped cubies, the cu...

Gear 32 teeth, pitch radius 16mm

4 required for whole assembly This is the second bone, the middle, finger bone (not middle-finger bone), for all four fingers, including the pinky.

This functionally tested Polyamid (PA 2200, Nylon) Part is used as a ventilation grid cap for the air ventilation system of a Ford Focus limousine....

4 required for whole assembly This is the tip of the fingers, not the thumb, of the bob

for servo "Modelcraft ES-05"

Replacement clip mount on the Verizon Droid1 case. This clip will fit into a $4 suction arm set from MPJA here: http://www.mpja.com/prodinfo.asp?n...

Firefly Ice enclosure outer shell part.

Firefly Ice enclosure battery cover.

Führungsstück Windschild Ducati Multistrada Modelljahr 2013. Wird 2 mal benötigt. Zur Beseitigung bzw. Milderung der Klappergeräusche die mit d...

Table top Roller Coaster, there is 2 ways to print this model. 1. print entire assembly with body and wheels. 2. print body and wheels separately...

Ten (10) tooth XL belt pulley for use with stepper motors with a 5mm shaft. Great for driving x and y axis belts on a Prusa or other RepRap 3d pri...