This part is a replacement firing pin for the delta-wing missile launcher in the Shogun Warriors Raydeen/Popy Brave Reideen Jumbo Machinder. The p...

Project Details: http://yzrandome.blogspot.com/2012/06/darker-than-black-heis-dagger-replica.html

A connection piece to be used between the oversize clamp and Busch & Müller Ixon Bicycle Headlights. It's modeled based on the original part, but ...

Part of a wire leg for a multirotor. Each leg needs two hinges. It is held to 1/2" (13mm) square arm with two zip ties. The hinge either holds the ...

This is a basic bezel to fit over the TimeSquared watch made by adafruit industries. The watch is excellent by itself, but the LED matrix that make...

This is a replacement part for the rewind drive of a Bauer P6 16mm film projektor. My projector had problems rewinding the film after viewing. It l...

2-Blatt Prop-Halter für EPP1045. Propellerachsen haben einen Durchmesservon oben 5mm, unten 4mm, um noch ein M5 Gewinde reinschneiden zu k&oum...

This is a Sheet Set for a Hollow Mini Mendel. Parts were made hollow to cut down on cost of printing. Just fill them with some sort of epoxy resin ...

Military tire for 1/24 scale truck.

this is a servo saver

feeder support for 8mm axis see OPENPNP project

Proportional Mixup was suggested by Alex Polonsky. The puzzle is a shape-mod of the Mixup Cube. By having rhombicuboctahedron-shaped cubies, the cu...

Gear 32 teeth, pitch radius 16mm

4 required for whole assembly This is the second bone, the middle, finger bone (not middle-finger bone), for all four fingers, including the pinky.

This functionally tested Polyamid (PA 2200, Nylon) Part is used as a ventilation grid cap for the air ventilation system of a Ford Focus limousine....

Female reversing ring for 58mm photography lens filters. Threads: 58mm x 0.75mm Length: 8mm Outer diameter: 62mm

4 required for whole assembly This is the tip of the fingers, not the thumb, of the bob

Landing gear for light Quadrocopters. For standard 10x10mm beams

for servo "Modelcraft ES-05"

Replacement clip mount on the Verizon Droid1 case. This clip will fit into a $4 suction arm set from MPJA here: http://www.mpja.com/prodinfo.asp?n...

Firefly Ice enclosure outer shell part.

Firefly Ice enclosure battery cover.

Führungsstück Windschild Ducati Multistrada Modelljahr 2013. Wird 2 mal benötigt. Zur Beseitigung bzw. Milderung der Klappergeräusche die mit d...

Table top Roller Coaster, there is 2 ways to print this model. 1. print entire assembly with body and wheels. 2. print body and wheels separately...

Ten (10) tooth XL belt pulley for use with stepper motors with a 5mm shaft. Great for driving x and y axis belts on a Prusa or other RepRap 3d pri...

Lenscap to integrate lens with eyepiece.

If you own a Sony wireless bluetooth lapel microphone (models ECM-AW3 or ECMHW2) you can place the microphone unit into the top and cover it with ...

8mm feeder for pick and place machine. OPENPNP project