Female reversing ring for 58mm photography lens filters. Threads: 58mm x 0.75mm Length: 8mm Outer diameter: 62mm

4 required for whole assembly This is the tip of the fingers, not the thumb, of the bob

Landing gear for light Quadrocopters. For standard 10x10mm beams

for servo "Modelcraft ES-05"

Replacement clip mount on the Verizon Droid1 case. This clip will fit into a $4 suction arm set from MPJA here: http://www.mpja.com/prodinfo.asp?n...

Firefly Ice enclosure outer shell part.

Firefly Ice enclosure battery cover.

Table top Roller Coaster, there is 2 ways to print this model. 1. print entire assembly with body and wheels. 2. print body and wheels separately...

Ten (10) tooth XL belt pulley for use with stepper motors with a 5mm shaft. Great for driving x and y axis belts on a Prusa or other RepRap 3d pri...

Lenscap to integrate lens with eyepiece.

If you own a Sony wireless bluetooth lapel microphone (models ECM-AW3 or ECMHW2) you can place the microphone unit into the top and cover it with ...

8mm feeder for pick and place machine. OPENPNP project

Part of Ultimaker extruder update by ghagen01 http://www.thingiverse.com/thing:15897 Have it made in steel. You also need the pin (model 530335)....

This is a spherical function that I thought turned out like a lemon squeezer, but I wouldn't actually advise using it for that purpose. It was crea...

Part of Ultimaker extruder update by ghagen01 http://www.thingiverse.com/thing:15897 Have it made in steel. You also need the wheeled shaft (mode...

This is an improved version of my Lacy Raindrop Bobbin. It's sized to fit Majacraft spinning wheels.

3 required for whole assembly This is the first bone, just off the knuckle, for the pointer finger, the middle finger, and the ring finger. That wo...

Gyrocam case for ContourROAM camera.

Battery mounting for 2xPanasonic LC-R127R2PG (12,7.2Ah) with Beijixing electric BJX58 controller (24V, 250W), part of my eBike project

One cross arm and two hinges and 3/32 wire make a single multirotor leg. Inspired by legs on Aerovironment Qube.

Air tube for vented subwoofer box.

Sakura Xpress X50 Tissue Processor Basket Handle

Adapter from Canon Eos EF bayonet connector to 58mm filter threads (M58x0.75). 6mm thick from camera body mating surface to front. 62mm outer dia...

Custom made adapter for all 3M sanders with self generated vacuum, so a tool balancer can be connected in a better and more secure location, great ...

This is a door release button for a Panasonic NNSD277B/W Microwave.

This functionally tested Polyamid (PA 2200, Nylon) Part is used as a ventilation grid cap for the air ventilation system of a Ford Focus limousine....

2 required for whole assembly This is the knuckle-joint for the middle, two fingers of the bob

A knob for my air conditiner, based on this model from Thingiverse.